Showing 19–24 of 89 results
-
Hex Nuts are almost always used opposite a mating bolt to fasten a stack of parts together. The two partners are kept together by a combination of their threads’ friction, a slight stretch of the bolt, and compression of the parts. we provide hex nuts that are extensively used in various application areas. These hex and heavy hex nuts are available in large and small sizes in various grades and finishes.
Standard:
DIN 934, ISO 4032, ISO 4033
Material:
Carbon Steel, Mild Steel, Alloy Steel & Stainless Steel.
Dia Range:
Metric Size: M06 TO M150
Imperial Size: 1/4” TO 6”
-
Standard:
DIN 439, DIN 936, ISO 4035
Material:
Carbon Steel, Mild Steel, Alloy Steel & Stainless Steel.
Dia Range:
Metric Size: M06 TO M150
Imperial Size: 1/4” TO 6”
-
A Coupling Nut is a long nut tapped from each side to meet in the middle, rather than all the way through in the same direction, used to connect two threaded rods end to end.
Standard:
DIN 6334
Material:
Carbon Steel, Mild Steel, Alloy Steel & Stainless Steel.
Dia Range:
Metric Size: M06 TO M100
Imperial Size: 1/4” TO 4”
-
A Nylon Nut is a kind of nut that includes a nylon collar insert. The insert is placed at the end of the nut and its inner diameter (ID) is slightly smaller than the major diameter of the screw. The insert deforms over the threads of the screw, but threads are not cut into the nylon. The nylon insert locks the nut in two ways. First, it forces the bottom face of the screw threads against the top face of the nut threads, increasing the friction between the two. Second, the nylon applies a compressive force against the screw itself.
Standard:
DIN 982, DIN 985
Material:
Carbon Steel, Mild Steel, Alloy Steel & Stainless Steel.
Dia Range:
Metric Size: M06 TO M36
Imperial Size: 1/4” TO 1-1/2”
-
A-Cap Nut has a closed nut having a dome-like cap over the back, protruding part of the engaged screw or bolt
Standard:
DIN 1587
Material:
Carbon Steel, Mild Steel, Alloy Steel & Stainless Steel.
Grade:
| 316 |
304 |
CL8 |
| CL10 |
904L |
Duplex |
-
A Square Nut is a four-sided nut. Compared to standard hex nuts, square nuts have a greater surface in contact with the part being fastened, and therefore provide greater resistance to loosening (though also greater resistance to tightening). Square nuts are typically mated with square-headed bolts.
Standard:
DIN 557
Material:
Carbon Steel, Mild Steel, Alloy Steel & Stainless Steel.
Dia Range:
Metric Size: M06 TO M150
Imperial Size: 1/4” TO 6”
Grade
